Specifications:
Pompkop: RVS AISI 630 /
17/4PH / 1.4542
Pump housing: painted cast iron
Plunger: fully ceramic
(aluminum oxide)
Valve construction: suction and pressure valves
made of stainless
steel
Crankshaft: forged, nitrided,
hardened and ground
Crankshaft bearing: quadruple plain bearings
with oil pressure lubrication
Drive shaft bearing: continuous with two
drive shafts
Piston guide: special aluminium
with graphite coating
Plunger seal: separated into high-
and low pressure
seals with
integrated
piston cooling
Reductions: internal reduction
available in three
versions
Plunger stroke: 90 mm
Min. inlet pressure: 2 bar
Max. inlet pressure: 5 bar
Oil quantity: 52/35 liters
Miscellaneous: oil pressure lubrication is
integrated, with
pressure gauge, monitoring,
oil/water cooler and
oil filter
